Benefits
Tetra Pak® Moulding machine RMC 2
Machine for moulding and setting mozzarella cheese
Tetra Pak® Moulding machine RMC 2 is used for shaping pasta filata type of cheeses such as pizza cheese, mozzarella and provolone into a variety of sizes and shapes.
The Tetra Pak Moulding machine RMC 2 is fully automated, requiring little or no operator intervention.
Quick facts
Machine for moulding and setting pasta filata cheese
Capacity:
1 ton/hr (2000 lbs)
Applications:
Pasta filata
Low-cost, low complexity
- Industry-leading hygienic design, with entire product contact area meeting 3A standards
- Compact equipment, ideal where factory space is limited
- Low complexity equipment for reliable operation and good product quality
Features
Moulder
Enables excellent fibre alignment, high quality product
The curved tubes of the moulder neck are designed with a large radius. This means the cheese follows a broad, gentle sweep, avoiding any sudden or aggressive turns that might disrupt the cheese fibres. Since the fibres remain aligned, the end product is of high quality.
Interchangable mould
Enables production of a variety of shapes and sizes
The machine can accommodate a variety of moulds, and can produce different weight classes within a mould section, provided they have the same cross section. This means you can easily produce pasta filata in different shapes and sizes, weighing between 2.5kg to 5kg, and from 200mm to 600mm long. Switching from one mould to another takes approximately 20 – 30 minutes.
Note: a non-stick coating is not always required, since the release zone is heated, allowing the cheese slide out in a natural way.
Indirect cooling
Increases food safety; reduces water consumption
Cold water is used to cool the moulds/cheese. The water is circulated inside the mould, so it never comes into direct contact with the product. This not only eliminates the risk of product contamination, but also means the water can circulate in a closed loop. No water is wasted, and the circuit does not require cleaning.
Control system RMC
Automatic operation and high reliability
This equipment is fully automated, requiring little or no operator intervention. Once the auger speed is set, the moulder augers are turned on and off by a level sensor. You can choose between an Allen Bradley or a Siemens control system.
